Valspar® Protective Sealer Natural Look

Valspar® Natural Look Protective Sealer locks out weather and scuffs with a tough, penetrating layer of invisible protection.

  • Invisible finish, silicone-infused to protect without altering appearance
  • Seals out weather and household chemicals
  • Easy to apply, dries to the touch in 2 hours

Opacity

Clear-Crystal Clear


Sizes

3.78 L / 1 Gallon

18.9 L / 5 Gallons


Coverage

7 m²/3.78 L - 14 m²/3.78 L

(150 sq. ft. per gallon)



HOW TO USE

  • Usage
    Exterior aggregate, concrete, brick, pavers, masonry, mortar and flagstone. Do not use on garage floors.
  • Prep
    All surfaces must be clean, dry and free of all loose, peeling paint or contaminants. Bare concrete: New concrete, masonry surfaces and mortar should be cured 60 days. Previously sealed surfaces: Clean with an all-purpose cleaner (TSP or substitute). Previously sealed surfaces must be porous and able to accept additional sealer. Test surface porosity before sealing
  • Application
    Use a roller or low-pressure, garden-type sprayer. While the first coat is still wet, apply a second coat to maximize protection. Allow 5–10 minutes for final penetration, then use a clean, dry cloth to wipe off all excess that did not soak into the surface. Do not pond or puddle this product.
  • Dry Time
    Dry Time @ 25 °C (77 °F) and 50 % Relative Humidity
    To The Touch: 1 hour - 1 hour
    Recoat: 1 hour - 1 hour
  • Clean-up & Disposal
    Clean up with warm, soapy water.
  • Recommended Coats

    1 coats

  • Dry to the Touch*

    1 hour - 1 hour

  • Recoat*

    1 hour - 1 hour

*Dry Time @ 25 °C (77 °F) and 50 % Relative Humidity

Data Sheets

Download the product data sheet (PDS) and safety data sheet (SDS) for your Valspar protective sealer natural look.

Product Number Base Container Size SDS PDS
042397705748 Clear 3.78 L
(1 Gallon)
SDS PDS
042397705755 Clear 18.9 L
(5 Gallons)
SDS PDS