Actual colour may vary from on-screen representation.
Valspar® Fast Prep® Ready-To-Use Solution
Valspar® Fast Prep® Ready-To-Use Solution is the crucial first step in most Valspar concrete-coating projects to ensure the best finish. Fast Prep extends the life of the coating, provides maximum durability and allows the coating to bond tightly to concrete. Fast Prep cleans, degreases and etches in one easy step, saving you time and money.
23 m²/3.78 L - 46 m²/3.78 L
(250 sq. ft. per gallon)
HOW TO USE
UsageBare, uncoated concrete
PrepSurface must be free of loose dirt, dust, leaves, dried paint or other debris. Use a stiff bristle broom to sweep floor. Clean out cracks and corners where dirt and other debris may be embedded or hard to reach. Tip: Use a leaf blower after sweeping to blow away any excess dust or dirt off surface. Wet the surface down completely with a garden hose.
ApplicationWear rubber boots, rubber gloves and eye protection at all times while using this product. Protect plants and landscaping from direct contact and runoff. Transfer into a plastic watering can. Do not use a metal watering can. Inspect floor for grease and oil stains. Spot apply Fast Prep™ directly to these areas and scrub thoroughly with a stiff brush. Rinse with water. Difficult areas may require a second application and scrubbing. Divide the surface into 10' x 10' sections. Pre-wet surface using a garden hose, avoid puddles. To apply Fast Prep, sweep watering can back and forth as you pour to ensure complete coverage. Using a stiff bristle brush, spread Fast Prep over section completely. It should begin to fizz or bubble, this is normal. Rinse all tools, material and personal protection with water before storing. Wash affected clothing.
Clean-up & Disposal